Ravan 17 Posted January 29, 2013 Report Share Posted January 29, 2013 rite dyed red and poly coated gloss I like how they came out. So that was the direction I was going, still need to trim down the psl hand guard, Picked up a Romak 3 stock set and a PSL handguard. (keeping the PSL lower handguard) picked up the cheese grater 1 piece gas tube hand guard for $19 at a gun show. BUT, now with the TAKD BASTARD coming out, and that I ordered one 3 weeks ago I am changing the direction. I have a Bolton FSB/GB coming this week, and a Tapco Razr flash hider coming, I am going to go 14.5 inches on the barrel and pin it on there. Brutalized but going to be so much better in 2 weeks. 2 Quote Link to post Share on other sites
pyzik 597 Posted January 29, 2013 Report Share Posted January 29, 2013 Is the PSL lower attached? What trimming is required? Would throwing a bolt on retainer work? I have been considering getting a PSL lower HG. Quote Link to post Share on other sites
Ravan 17 Posted January 30, 2013 Author Report Share Posted January 30, 2013 No it was just there for looks I'm still trying to figure out how to attack it. 1 Quote Link to post Share on other sites
vulcan16 971 Posted January 30, 2013 Report Share Posted January 30, 2013 Your off to a very good start. Quote Link to post Share on other sites
avnate 335 Posted January 30, 2013 Report Share Posted January 30, 2013 I can't wait to see this Quote Link to post Share on other sites
Ravan 17 Posted January 30, 2013 Author Report Share Posted January 30, 2013 I wish could use the stock still but thats ok I'll sell it and go with something else maybe a bonesteel side folder. Not sure just yet. 1 Quote Link to post Share on other sites
Ravan 17 Posted February 6, 2013 Author Report Share Posted February 6, 2013 threading barrel tonight, going to take the thread down to the final spot and scribe the barrel where I want to cut it. have the Bolton gasblock, let me tell you it is sweet. trying to decide if I want to rust blue the rifle or take it and get it duracoated. after I blue it or duracoat it I am going to chop the barrel down 1.5 inches or maybe 2 inches and then pin the tapco razr flash hider on it. Quote Link to post Share on other sites
jerry52 893 Posted February 6, 2013 Report Share Posted February 6, 2013 Hey! thats not one of them assault rifles people killers, that Senator Boxer is talking about is it? Looking good ! How are you going to do the pistol grip? Dremel? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.