TigerMoses 31 Posted July 2, 2013 Report Share Posted July 2, 2013 Here what I think I know: 1) setup target at 100m 2) aim at bulleyes, shoot 3) adjust to impact point (both knobs as needed) 4) shoot, should be good (perfect world) Loosen turret outer screws, adjust elevation middle turrent (with numbers, not top dial) and set to 1 (or is it actually zero?) and then tighten screws. Similar process for windage ( this one is to zero) So if now I rangefind to 400 meters, I just set top dial to 4 and use top chevron, aim shoot (right?) I know the 2nd chevron is for 1100 meters, but what should the elevation dial be on? 0 or 1 or 10 I'm never going to shoot 1100, but I want to explain it right if ever asked Quote Link to post Share on other sites
psl sniper 963 Posted July 2, 2013 Report Share Posted July 2, 2013 check this out, might be what your looking for. http://www.dragunov.net/docs/pso_scope_zero_manual.pdf personally i dont use the hold over chevrons, mostly because ive never shot that far. Quote Link to post Share on other sites
SGL 530 Posted July 2, 2013 Report Share Posted July 2, 2013 Coincidentally, the Pawn Shop Guys (Iraqveteran8888) touched on this in one of their videos today. Probably not in-depth enough for your tastes, but my first introduction to that reticle style. (relevant info on com-bloc scopes starts at 8:40) http://www.youtube.com/watch?v=Yj1Edg9TReI Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.