Brettsaiga12 1 Posted February 9, 2014 Report Share Posted February 9, 2014 when cutting down the barrel 3 inches from 19 to 16 inches, does the taper of the barrel (added diameter closer to the gas block), affect rethreading? do you have to sand down the barrel before you start running the die? Quote Link to post Share on other sites
haugpatr 972 Posted February 9, 2014 Report Share Posted February 9, 2014 Make sure you are following federal law is my advice. Quote Link to post Share on other sites
Billybobf 50 Posted February 9, 2014 Report Share Posted February 9, 2014 (edited) Yeah, you got you short barrel shotgun stamp? Rifle is 16 shotgun is 18 And being you have four posts might make us nervous Edited February 9, 2014 by Billybobf Quote Link to post Share on other sites
Brettsaiga12 1 Posted February 9, 2014 Author Report Share Posted February 9, 2014 (edited) i do know the laws reguarding barrel thength, it will be 18.2 inches with the muzzle break permantly attached. now thats out of the way, does anybody have advice for my question? Edited February 9, 2014 by Brettsaiga12 Quote Link to post Share on other sites
poolingmyignorance 2,191 Posted February 9, 2014 Report Share Posted February 9, 2014 http://forum.saiga-12.com/index.php?/topic/91872-i-am-cutting-my-v-12-to-pin-a-brake-on-which-one/?fromsearch=1 Your answer lies within this thread. Quote Link to post Share on other sites
Brettsaiga12 1 Posted February 9, 2014 Author Report Share Posted February 9, 2014 http://forum.saiga-12.com/index.php?/topic/91872-i-am-cutting-my-v-12-to-pin-a-brake-on-which-one/?fromsearch=1 Your answer lies within this thread. point taken, thanks for the info 1 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.