Mountain Man 20 Posted May 15, 2014 Report Share Posted May 15, 2014 So, I wanted to use PWS FSC 556 that uses 1/2x28 RH Threads and found a great 14x1 LH to 1/2x28 RH Thread Adapter at CNC Warrior. Since CNC is a LH twist and the PWS is a RH twist I am going semi permanently attach the CNC adapter piece so I can tighten the PWS without the CNC spinning lose. My question is what should I use? Red or Blue locktite? Teflon tape really only helps with indexing, any recommendations? Quote Link to post Share on other sites
termite 463 Posted May 15, 2014 Report Share Posted May 15, 2014 Red, some say it's permanent, but with a "little" heat, it'll turn loose. I use it almost everyday, and get cussed by lots of people for using it, but the parts don't work loose in my pumps. Quote Link to post Share on other sites
Mountain Man 20 Posted May 15, 2014 Author Report Share Posted May 15, 2014 Red, some say it's permanent, but with a "little" heat, it'll turn loose. I use it almost everyday, and get cussed by lots of people for using it, but the parts don't work loose in my pumps. Do you think it being applied on a thread adapter connected to the barrel with a lot of heat generated would negate its benefits while shooting, and it loosen significantly? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.