Jump to content

1/2x28 RH Thread Adapter

Recommended Posts

So, I wanted to use PWS FSC 556 that uses 1/2x28 RH Threads and found a great 14x1 LH to 1/2x28 RH Thread Adapter at CNC Warrior. Since CNC is a LH twist and the PWS is a RH twist I am going semi permanently attach the CNC adapter piece so I can tighten the PWS without the CNC spinning lose. My question is what should I use? Red or Blue locktite? Teflon tape really only helps with indexing, any recommendations?

Link to post
Share on other sites

Red, some say it's permanent, but with a "little" heat, it'll turn loose. I use it almost everyday, and get cussed by lots of people for using it, but the parts don't work loose in my pumps. smile.png


Do you think it being applied on a thread adapter connected to the barrel with a lot of heat generated would negate its benefits while shooting, and it loosen significantly?

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Chatbox

    Load More
    You don't have permission to chat.
  • Create New...