Jump to content

What sights for Chaos Titan full length rail?


Recommended Posts

Recently I picked a Chaos Titan quadrail with full length top rail and now I'm sightless. I have seen the Chaos HK sights that are recommended for this but I am looking for suggestions on what others have used. I'm looking for something around the price of the HK sights, $100, either red dot, holographic, or iron sights. Restore my sight to my Saiga 12!!!!

Link to post
Share on other sites

I think the magpul sights wouldn't be too bad, and I think the micro dot may be a little too small for me to visually target. How far back on the rail did you mount it to so it didn't seem like the dot was too far away? My ultimate goal would be to mount something similar to the krebs custom ghost ring setup. Something low enough that I would not have to raise my head to high to see but also something that doesn't have a rediculously long sight plane, unless that would be better for shooting? I have had that setup on a previous saiga 12 build and in my opinion, it is the best iron sight setup for this shotgun.

Link to post
Share on other sites

I like red dot set ups. My eyes are getting too old for blade type iron sights, although I can still do pretty well with peeps. I say that because you are asking the opinion from some one who has already made the jump to red dots on most of my rifles that are not setup for long distance shooting. So I may not be the most objective opinion out there.

 

As far as the two red dots in question. The BSA is the 30mm Stealth tactical with the laser and flashlight attachment removed. It is a well built re dot and be had for around $70. It is on the heavy side, but very manageable. The best thing about it is built in dust caps that close with rotation of the front and rear eye pieces, and a huge objective that gives a clear field of view. With both eyes open, the scope disappears and the red/green dot superimposes in your field of view. Down side is weight.

 

The PA MD-06 is very light and has been dependable on everything I have mounted it on. It comes in two different flavors: one with the control dial on the left and another with the control dial on the right. I learned the hard way to get the one with the controls on the left to make sure brass does not hit the dial upon ejection. It has performed well on my S12, although it has been mounted on a side rail mount as opposed to the top of the receiver. I would think being mounted on top of the Chaos that close to the action, would cause it take a little more of a beating, but in short, yeah I think it would hold up. The upsides of the PA microdots are definitely their small size and durability. The down side is that the emmitter for the red dot is located at the 7:30 position and obscures some of your field of view. The sight picture is not as good as a result. I have gotten used to it, but some people hate it. The other drawback is the mount that comes with it is junk in my opinion. They are over sized without enough adjustment to tighten down completely on some rails. The up side it the the red dot itself conforms to an Aimpoint mount, so there are plenty of high quality mounts than can be purchased for it. My 300 BLK uses one with a Seekins precision mount to co-witness with the front sites.

 

Sorry for the long-winded response. Hope this helps.

Link to post
Share on other sites

Do you have a model number or any reference to the red dot sight you have? Weight for me isn't a concern as it already weighs about 8 lbs empty.

BSA Stealth Tactical http://www.bsaoptics.com/product.aspx?product=STSRGBD20LL&productID=461

 

Other interesting options here:

http://www.bsaoptics.com/family.aspx?familyID=16&filter=tactical

Edited by Spacehog
Link to post
Share on other sites

Thanks for the advice spacehog. I picked up the same one you have listed above for a really good price and I will be receiving it soon. I'll try it out and let you know the results. If I don't like it, I will just sell it and probably just get some chaos HK sights.

  • Like 1
Link to post
Share on other sites

The Chaos irons will be considerably lower than any other rail-mounted irons you will find. AR-height irons will be pretty tall, which is sorta unnecessary on this platform. Typically, a longer sight radius is preferred so most folks mount their sights as far apart as possible. Only exception is that some people like a ghost ring aperture to be a little farther forward. 

Link to post
Share on other sites

I really wish a company made a dovetail picatinny rail adapter that would allow the use of a dovetail rear sight such as a tritium nightsight or a ghost ring sight. Having this quadrail is more like an experiment with sights for it.

Link to post
Share on other sites

A peep sight and a ghost ring are 2 different things. I need something more open like a ghost ring. Peep sights are more for precise rifle shooting. Now if they opened up the aperture more then maybe I would be interested. I would have to get a front sight that sits about the same height as that one.

Link to post
Share on other sites

Nothing a decent drill can't open up. wink.png

 

Red dot and call it a day. The flip up options look like they require a horrible cheek weld.

 

Edit, maybe a LGS can cut dove tails into a coupe rail slots, one out front, one in back.

Edited by Mullet Man
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Chatbox

    Load More
    You don't have permission to chat.
×
×
  • Create New...