csspecs 1,987 Posted January 8, 2016 Report Share Posted January 8, 2016 So while assembling M77 magazines we found one that was completely unserviceable, so we did a rust test vs our old standard finished Vepr .308 magazine also unserviceable. So here are the results of three months outside. All of October, November and December these sat outside. I flip the magazines every few days to allow all sides equal exposure. The block is set at a low angle to allow eventual drainage and drying. We started the test by wiping the black nitride magazine with alcohol to remove any oil coating. The bare steel is marked 9-30 the day the test started, I intend to leave these out one year. Black oxide on left Black Nitride on the right. Steel plate below is marked 9-30 which is the day the test started. Showing the pair of steel jacket round loaded at the start of the test. The rust stains inside the magazine wipe off, finish is still holding out. You can see the damage to the feed lips, that is why this magazine was used. You can see the rust washed into the magazine from the top and residue was left on the bottom, again it wipes off. The spring seems to be rust free still, the rust on the follower and retainer plate is from the ammo. Follower with the rust wiped off. I started a new pair of magazines on 1/1/16 one steel G3 magazine and one of our new style Vepr .308 magazine. G3 is already sprouting rust scale. 7 Quote Link to post Share on other sites
JESS1344 508 Posted January 8, 2016 Report Share Posted January 8, 2016 (edited) CSS, SO, YOU'RE BLACK NITRIDING YOUR MAGAZINES NOW? THANKS, JESS1344 Edited January 8, 2016 by JESS1344 Quote Link to post Share on other sites
gunfun 3,931 Posted January 8, 2016 Report Share Posted January 8, 2016 Worth a few thousand words. Quote Link to post Share on other sites
csspecs 1,987 Posted January 9, 2016 Author Report Share Posted January 9, 2016 CSS, SO, YOU'RE BLACK NITRIDING YOUR MAGAZINES NOW? THANKS, JESS1344 Yep, almost everything is Black Nitride, the last part to be black oxide finished was the Saiga-12 followers. Every Saiga-12 has been BN, as have the Vepr-12, M77, current model Vepr .308, current Saiga 20 ga, and the current AK floorplates. We have a couple old items like some of the sizes of Saiga .308 magazine, and the Saiga 100 magazines are black oxide. Black Nitride is better for us because we don't have the oxide bleed out to clean off, we used to soak the magazines overnight to clean it out, and it still came back. PS you can actually start a fire using a hard steel tool and the side of a magazine. It does scuff up the finish badly. 3 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.