Looper36 2 Posted June 22, 2016 Report Share Posted June 22, 2016 I installed a new Krebs safety selector lever today. I had to reinstall the stock one because my new Krebs detent did not match up. It's about 2 mm off. Has anyone had this problem? Does anyone have a good fix? Thanks. Quote Link to post Share on other sites
spicoli 12 Posted June 22, 2016 Report Share Posted June 22, 2016 I had the same problem. Krebs solution was to file the pin flush with the receiver. I sold mine. Quote Link to post Share on other sites
Looper36 2 Posted June 22, 2016 Author Report Share Posted June 22, 2016 I'm thinking the same. I don't want to spend hours on it. Quote Link to post Share on other sites
JESS1344 508 Posted June 24, 2016 Report Share Posted June 24, 2016 GUYS, AS I RECALL, THEY SELL TWO DIFFERENT ONES WITH THE DETENT TO MATCH WHICHEVER TYPE YOU HAVE. CHECK THEIR SITE. JESS1344 Quote Link to post Share on other sites
Mullet Man 2,114 Posted June 24, 2016 Report Share Posted June 24, 2016 Even the Saiga specific safety doesn't line up on a saiga. Both mine are off by an 1/8" or so. I definitely wouldn't get rid of it because of that. It's a great piece. Quote Link to post Share on other sites
Looper36 2 Posted June 25, 2016 Author Report Share Posted June 25, 2016 I'm thinking I will fill the old detent and drill a new one. I looked at trying to pound or file the Krebs, way too much hassle. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.