Jump to content
Sign in to follow this  
Saiga556

Finally converting my 16" .223

Recommended Posts

Hello to the Hive,

 

I had an account here years ago and lost it. Back on after about half a dozen years, and lurking more recently.

 

My Saiga .223 was purchased going on 10 years ago. Serial range H0616XXXX. I've got by so far with a Dinzag gas tube and some aftermarket furniture. Dragunov stock etc. I almost got an old UA mag adaptor to work, but lots of filing and fettling broke it and gave that up. The adaptor required Dinzag's bullet guide, which is still waiting in the wings for another try with a better adaptor and more patience.

 

Yesterday after a visit to Dinzag's site and viewing his conversion kits, and tired of looking at my half-assed attempt at compliance or conversion or something, I could not resist and popped for the following.

 

CONVKIT1D  - deluxe PG conversion kit.

RAMSTG2 - Trigger guard 2 kit

SAIGAPIK - Saiga gas piston install kit

 

I have a US made handguard and retainer, with a US pistol grip and buttstock (not sure which to go with) and the following:

Gas piston, Gas tube (not sure it counts), Trigger, Hammer, Disconnector - the rifle should be compliant with 922r overall.

 

Ok. More questions to come. Really enjoying looking over the gallery since I was last active. Quite a bit has changed.

Edited by Saiga556

Share this post


Link to post
Share on other sites

Gas tube and handguard retainer don't count.  Currently with the pistol grip, stock, handguard, piston, hammer, dis-connector and trigger you're good to go.
This puts you at 8 foreign countable parts.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×