goldenpony 61 Posted July 11, 2017 Report Share Posted July 11, 2017 I have a CSSPECS 8 round steel magazine that I bought quite a while ago. When I first got it I ran some rounds through it and it seemed OK. I haven't done anything with it in quite a while, but I loaded it up yesterday and tried to use it. I first loaded 5 rounds in it and all 5 ran fine. Loaded up some more and now the first round "jams" and will not load. Took that round out and tried again, same thing. I took those rounds out and put them in a different mag and all ran fine. loaded up another mag and it ran fine too. Loaded the CSSPECS mag up again and the same thing. Puzzeled. I am going to try to get a hold of CSSPECS and discuss it with them. Quote Link to post Share on other sites
G O B 3,516 Posted July 11, 2017 Report Share Posted July 11, 2017 Did you pull the mag apart and clean / lube it? How about the feed lips, they might need attention? Quote Link to post Share on other sites
csspecs 1,987 Posted July 13, 2017 Report Share Posted July 13, 2017 Does your mag hold 9? There was an updated follower back a year ago or so. Quote Link to post Share on other sites
goldenpony 61 Posted July 13, 2017 Author Report Share Posted July 13, 2017 I think I got that updated follower-I'll check and see how many it holds. Quote Link to post Share on other sites
goldenpony 61 Posted July 13, 2017 Author Report Share Posted July 13, 2017 I have tried many times to call CSSPECS, left some voice messages and tried to email them with no reply. Are they still in business? Quote Link to post Share on other sites
csspecs 1,987 Posted July 13, 2017 Report Share Posted July 13, 2017 Im on vacation actually. Voice mail forwarding was not working yesterday. The updated follower has an extra spring guide in the follower. It would have two spot welds in the center of the top side visable when assembled. Quote Link to post Share on other sites
goldenpony 61 Posted July 13, 2017 Author Report Share Posted July 13, 2017 ^ Gotcha. Sorry to disrupt your vacation. OK, I see the two spot welds on the follower. ^ Please contact me when you get back to work. Thanks Jim Ray Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.