Jump to content

palves3600

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About palves3600

  • Rank
    Newbie
  • Birthday 02/25/1946

Profile Information

  • Gender
    Male
  • Location
    Montgomery, AL.
  1. Short rail bolted to the receiver thru the aft handguard attach point, and another bolt, drilled and bolted thru the aft part of the hg. Might need to shim w/washer to even up. Much like an SVD, most of the weight is absorbed by the receiver (90%) instead of the hg which would load up on the barrel. The less on the barrel the better,
  2. palves3600

    100_1885.JPG

    Thanx guys. I haven't been reading the forum in some time. Been tied up with building a new house. I am trying to locate flash hiders left over from the 'clip and hider' setup for the Saiga rifles that didn't work out. The Phanton hider part works great for an alternative installation for the 308's,, without having to thread the barrel.
  3. palves3600

    100_1885.JPG

    © © Saiga-12.com

×
×
  • Create New...