Jump to content

PlinkinPark

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About PlinkinPark

  • Rank
    Newbie
  • Birthday 02/19/1965

Profile Information

  • Gender
    Male
  • Location
    hi desert
  1. Finally put the gas piston and FCG that I bought from Dinzag Arms into service. Very clean, very smooth! Put a few hundred rounds downrange. Great way to spend the day off! THANKS DINZAG!
  2. I picked up some SureFire Metal 30 rd mags from TheGunSource for $40.24. Great fit. Already had the mods. They were European, so no compliance parts, but they worked great!
  3. No -- all you need is a hand drill and a hammer. Drill out the pin that holds the piston onto the bolt carrier, unscrew it, screw the new one on, then drill the new hole, insert a pin and peen it over. Start to finish, the whole process takes about 15 minutes. You can either get a specific pin for the piston 3 mm), or you can use a small nail. There's a guy called Hotbarrel over on Gunco.net that sells US-made gas pistons for $15 each (delivered). I got one and it very well done (it does has the grooves, though, not the smooth head). Easy and permanent. As far as the trigger -- it
  4. Can I keep my trigger group in the stock location? I like the rear mounted trigger and the Saiga Skeletonized Stock, but I want the US parts. Do the TAPCO single-hook just drop in, or do I need to mod the receiver?
  5. PlinkinPark

    ???

    You don't have to modify your gun to make them work, but you do have to make mods to use them legally -- that's Federal law. Depending on where you live, your State may also have limits on magazine capacity (like Kalifornia, Maryland, New Jersey and New York). Make sure you read up on 922R ................the fact that just because you can do something, doesn't mean it's legal. Jim Are there any HC mags with US parts? I can't tell from the descriptions on the web - Joe Lowe Clips and SureFire aren't specific....any first hand info? .....anyone....anyone.....Bueller....
×
×
  • Create New...