.410 conversion

[nagelmaker 0]

need a complete list, will probably go with Dinzags trigger group. i'm going to keep the bho. the retaining options and applications are a little foggy to me. i assume the pins are grooved just inside the receiver on there head end? whats better, Eclips or retainer plate? thanks for any help. anyone in eastern iowa thats done this?

[Superhawk138 202]

need a complete list, will probably go with Dinzags trigger group. i'm going to keep the bho. the retaining options and applications are a little foggy to me. i assume the pins are grooved just inside the receiver on there head end? whats better, Eclips or retainer plate? thanks for any help. anyone in eastern iowa thats done this?

If you go with Dinzag's FCG the BHO will work. If you use a Tapco you will have to grind the hammer to match the factory hammer for the Bho to work. Make sure you have a pistol grip nut and bolt and you will more than likely have to cut a square hole for the pistol grip nut. A axis pin retainer plate works good or you can modify the original retaining wire to work. Cobra 76 Two has a pictorial write up on how to modify it.

 

Buttstock

pistol grip with nut and bolt

retainer plate or modify wire

good screws or rivets for trigger guard i use the Tapco hardware.

Nylon hole plugs for original trigger pin holes

Fire Control Group

Optional stuff for compliance and or looks. Handguard, Muzzle break, Tromix or Chaos gas piston puck

Good luck with your build.

Edited August 10, 2008 by Superhawk138

[nagelmaker 0]

thanks superhawk! with all the info here and a cd i got from messiah jones i know i can't go wrong. i want a green/olive stock/grip. the forearm will be down the road, mayby i'll try dyeing/painting it. i was going to buy a 12 but gotta get another car.