AlanW 0 Posted February 1, 2004 Report Share Posted February 1, 2004 Guys, When you completed the conversion process to make the saiga's legal how did you remove the gas piston pin. I used a hammer and punch and a few words to get mine out but destroyed the pin in the process. I cleaned the threads and then applied the red thread locker to the threads. The gas piston was a tapco product not having the hole drilled through it. Is there an easier way? Has anyone installed the tapco saw pistol grip on their rifle and if so, how. All I received with my grip was the grip, a 1.5" screw, a 1"x1/2 plate and a washer. Is there more? Anyone know how to remove the rear site from the rear site base? Thanks in Advance for Assistance Alan Weinbrenner weinfamily@mpks.net Quote Link to post Share on other sites
dahun 0 Posted February 4, 2004 Report Share Posted February 4, 2004 Try RSA here, this should be a good start. Don't know about the pistol grip tho... Dahun Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.