ugadawg34

I'm selling my Saiga 308 and have 6 SUREFIRE 308 mags (25 rounders) for sale on Gunbroker at the link below. $150 for 6 magazines. 4 are new unopened in the original pacjaging the other 2 are opened and have about 20 - 30 rounds through them with no issues. Wanted to pass along a good deal to the frum; link is below:

OK maybe I'm confused. I thought that I had to use 10 or fewer foreign made parts to comply with 922r if I added a pistol grip or greater than 10 round magazine capacity? The Tapco PG stock is 1 US part and the Surefire mags are 3 US parts so together I'm fine but using the Tapco PG stock with the factory mag leaves me with just 1 US made part and 13 foreign? I've read the 922R compliance sections of the site - but maybe I missed something. Pls advise

Thanks - what is advantage of Dinzags gas piston kit? Difficulty / cost?

I've upgraded the synthetic stock to the Tapco and gotten the Surefire 25 round mags. If I understand the 922r (most idiotic law that I've seen) I'm compliant when using the Surefire mags but if I use the stock mag I'm non compliant. I would like to make another upgrade to a US part or parts that would be an improvement, easy to put on, not too $$$ and a tactical or performance upgrade. I would love to hear some suggestions. Thanks

This is my first post after finding the site a couple of weeks ago. My problem is that my new unfired Saiga 308 bolt is stuck in the rear position. I have tried pulling it back, pushing it forward, pulling it while pressing the BHO, moving the safety and every combination that I can think of. Maybe I'm missing some easy solution but I'm at a loss. Thanks for the help!