Sanjuro82

Hey bunker I not sure exactly what you're looking for with the pics...but here are a couple that took that shows the safety inside the receiver. The safety is the cylinder right behind the hammer in the pics.

Bunker I'll try to snap some closeups later today for you.

College Station here!

Finally got it back in! I tried using a small screwdriver to lift up the wire but I couldn't quite get it. So I pulled the safety back out, lubed up the angled portion on the safety, put it in and made sure everything was lined up properly and then gave it a sharp whack with a hammer and a dowel rod. Popped right in!

That definitively does make sense. I figured that was the way to re-install it but I want to make sure before I pushed to hard on it. I gonna use a small screwdriver to see if I can push the wire up enough to slip it by. Thanks for the help!

I recently separated the stock from my Super Vepr 308 so I could put some coats of linseed oil on it. I noticed that the push button safety had to be removed to allow the separation. I used a screwdriver to rotate the safety 180 degrees and then pushed it out. Easy enough....or so I thought. Well after I got the safety out, I removed the stock and started the linseed coats. After about 6 coats the stock looks really awesome now, but I've run into a bit of a snag on re-install. There is a retaining wire that is blocking the hole that the safety need to slidethrough on the left side of t