SeanByrd

Thanks for the replies. A little history on gun. Bought new, CSS conversion kit, 4 gas ports unobstructed. I did shoot 15 cheap Winchester rounds before the conversion kit. It cycled all 15 flawlessly. I don't remember specifics on the shells, just some I had laying around from last years dove season. I'm sure I got them at Walmart. It won't cycle 3dram winchesters with factory plug, or auto plug now.. I'm gonna take your suggestions and do some reading.

I installed the auto plug per instructions, couldn't get Winchester 3 dram heavy target loads to cycle at all. I was able to cycle 3 3/4 dram #6 with no FTF or fte's. The auto plug was turned about halfway down from flush to get the 3 3/4 dram to cycle. I have 4 gas ports. Question? Can you run it without the puc? What should I try next?

Ok, thanks

Just ordered one. Question, do you use the stock puc with the tac 47 system?

Thanks, this is exactly what I was looking for. These Rio's are high brass, and this is the problem that I'm having.

Tried it on all 3 10 rounders. Followers seem to move freely on all 3

Hey guys, new member here. Been trolling a while. Got a saiga 12 with CSS conversion kit. After conversion kit install, I went to test fire. Shooting Rio #6 3 3/4 dram, 2 3/4 ". Shoots flawlessly with factory 5 rd mag. I have 3 SGM 10 rounders that are not feeding properly. Is there anything I can do to the mags to help them feed better? They seem a bit tight.