snuffy

So those little white dremel drums do come in handy. Never really used them before. Thanks.

I read a lot about people "polishing" their triggers to improve them, but I'm not sure how to do it. Is it accomplished with sandpaper or an actual buffing wheel? How would I know where to polish and to what extent? Sorry for the noobish question.

Cool-just what I needed to know. To me, the FSE hammer was obviously different than the original, but it didn't occur to me to compare the height of the two triggers. Just out of curiosity, are certain FCGs considered better or more desireable than others or is it just personal taste? Thanks.

OK I see it now, That is the back of the bolt carrier with the hook sticking up behind it. That is the same problem I delt with which is no problem. Yeah in the picture the trigger is sticking straight up and I'm pulling back on the handle. I plan on getting the shorter barreled saiga 308 and 12 (I currently have the long barreled versions) and doing a conversion on those. I think I'll take out the FSE trigger and drop it in the 308. Then I'll get two Tapco triggers to put in the S12s. That way, I can save a little work-unless the tapco triggers have the same issue. Then I guess I'

I'll give the dupli-color a shot. I too had to reshape the hammer, but the trigger seemed ok until now. i'm afraid that if I trim the trigger, it might have trouble catching the hammer. Thanks for the input.