xbox360 1 Posted May 24, 2009 Report Share Posted May 24, 2009 (edited) http://www.cross-conn.com/Saiga_Conversion/Step_2.htm discard pins?? well how do I put it back together! :/ ??? [first picture says PINS to drill] how do I get more of these :/ Edited May 24, 2009 by xbox360 Quote Link to post Share on other sites
Superhawk138 202 Posted May 24, 2009 Report Share Posted May 24, 2009 Those 4 extra holes will not be used after your conversion. You can put plastic plugs, screws, rivets, or weld them up. Quote Link to post Share on other sites
xbox360 1 Posted May 24, 2009 Author Report Share Posted May 24, 2009 but wont I need those pins to hold my other parts in? Quote Link to post Share on other sites
xbox360 1 Posted May 24, 2009 Author Report Share Posted May 24, 2009 I found these at my local ACE Hardware store. The technical description is "8-32 x 1-3/8 binding post and screw". The Hillman P/N is 3833-L. They are basically anodized, unfinished aluminum (steel would have been nice). They will be refinished when I refinish the receiver. read step 7, Did you guys get these? Quote Link to post Share on other sites
Superhawk138 202 Posted May 24, 2009 Report Share Posted May 24, 2009 but wont I need those pins to hold my other parts in? Nope. the only pins you will reuse are the Trigger pin and the Hammer pin. Then use your retaining plate, shepards crook, or E-clips to hold them in Quote Link to post Share on other sites
Superhawk138 202 Posted May 24, 2009 Report Share Posted May 24, 2009 I found these at my local ACE Hardware store. The technical description is "8-32 x 1-3/8 binding post and screw". The Hillman P/N is 3833-L. They are basically anodized, unfinished aluminum (steel would have been nice). They will be refinished when I refinish the receiver. read step 7, Did you guys get these? I just use some cheap 3/16" plastic hole plugs from Lowes. Quote Link to post Share on other sites
xbox360 1 Posted May 24, 2009 Author Report Share Posted May 24, 2009 but wont I need those pins to hold my other parts in? Nope. the only pins you will reuse are the Trigger pin and the Hammer pin. Then use your retaining plate, shepards crook, or E-clips to hold them in are the pins already on my gun or is it in some KIT.... Quote Link to post Share on other sites
Superhawk138 202 Posted May 24, 2009 Report Share Posted May 24, 2009 (edited) but wont I need those pins to hold my other parts in? Nope. the only pins you will reuse are the Trigger pin and the Hammer pin. Then use your retaining plate, shepards crook, or E-clips to hold them in are the pins already on my gun or is it in some KIT.... They are allready on your gun holding the factory hammer and sear and disconnector. The ones that look like this you reuse. Edited May 24, 2009 by Superhawk138 Quote Link to post Share on other sites
xbox360 1 Posted May 24, 2009 Author Report Share Posted May 24, 2009 Thank you so much I didnt want to start drilling away pins that I thought I would need lol... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.