T1gger 3 Posted March 12, 2010 Report Share Posted March 12, 2010 (edited) Opinions??? BTW: It'll either be that one or the one from Belarus Edited March 12, 2010 by T1gger Quote Link to post Share on other sites
Rhodes1968 1,638 Posted March 13, 2010 Report Share Posted March 13, 2010 Have one that works fine but am a little concerned the release lever is a weak point so looking at ways to beef that up a bit. The low profile really makes a difference using the scope. Quote Link to post Share on other sites
jtboss 0 Posted May 20, 2010 Report Share Posted May 20, 2010 Have one that works fine but am a little concerned the release lever is a weak point so looking at ways to beef that up a bit. The low profile really makes a difference using the scope. Does it being lower make it easier to get the correct eye relief ? It's got to help your neck,not having to stretch to see through it. Quote Link to post Share on other sites
ktcm7271 999 Posted May 21, 2010 Report Share Posted May 21, 2010 I've got a Belaruse on my S-12 and I had to mill the slot about 3/8" further to get the slide over the groove. Then I noticed the slide is square and the groove is concave, so it wouldn't lock up. I cut off the lever mechanism and drilled and tapped two set screw holes. It's on there good, but no longer quick change. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.