overweightelf 0 Posted April 24, 2005 Report Share Posted April 24, 2005 laltey i been noticing my firing pin isn't hitting the primer hard enough, and i am starting to get a couple of jams, and i haven't before and i converted my rifle awhile ago, any suggestions? Quote Link to post Share on other sites
shotgunman 0 Posted April 24, 2005 Report Share Posted April 24, 2005 (edited) I would say remove the pin and clean it real good I had a polytech that did that to me due to dirty ammo ,if you dont want to remove it soak your bolt in some good gun solvent or degreaser and blow it out with compressed air hope this helps,also check the spring on your hammer if its not on just right or something slows your hammer and it dont strike hard enough that could do it I had that happen on a bushmaster AR I had when a replaced my hammer spring with a cheap aftermarket spring Edited April 24, 2005 by shotgunman Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.