pinetopfirefighter 34 Posted May 1, 2011 Report Share Posted May 1, 2011 I am going to be installing my G2 FCG tomorrow. I have seen various conversions regarding the use of retaining clips to keep pins from backing out. However, using the cross-conn instructions and binding posts, I do not see that any retaining clips were used. Did I miss something? In addition, I will not be using the BHO. Any advise is greatly appreciated. Quote Link to post Share on other sites
pinetopfirefighter 34 Posted May 1, 2011 Author Report Share Posted May 1, 2011 More reading and watching videos. So, the e-clips are for the trigger axles and the binding posts are simply for filling the holes that were drilled out? I think. Quote Link to post Share on other sites
kresk 10,063 Posted May 1, 2011 Report Share Posted May 1, 2011 More reading and watching videos. So, the e-clips are for the trigger axles and the binding posts are simply for filling the holes that were drilled out? I think. Clips for trigger and hammer, posts for the left-over holes. Quote Link to post Share on other sites
pinetopfirefighter 34 Posted May 1, 2011 Author Report Share Posted May 1, 2011 More reading and watching videos. So, the e-clips are for the trigger axles and the binding posts are simply for filling the holes that were drilled out? I think. Clips for trigger and hammer, posts for the left-over holes. I appreciate it. Trying to get everything straight and parts acquired before starting tomorrow. Nothing worse than stopping to run to the hardware store in the middle of a project! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.