Seggah 1 Posted September 24, 2011 Report Share Posted September 24, 2011 After firing, the trigger doesn't reset even if I push the trigger forward. I would have to remove the dust cover and push the hammer down. Any ideas? Quote Link to post Share on other sites
ChileRelleno 7,071 Posted September 24, 2011 Report Share Posted September 24, 2011 Is this gun converted? Make sure the legs of the hammer spring are in position on the back of the trigger. They can slip inwards and bind it up, or one or both can slip off. Where the spring's coils come off the hammer, give each a slight bend towards the receiver. Hammer isn't in backwards is it? Check the trigger axis pin and disconnector for any burrs. Is the trigger binding on the pin? Disconnector spring seated/functioning properly? Check where the wear marks are forming, anything out of the ordinary? Quote Link to post Share on other sites
Seggah 1 Posted September 25, 2011 Author Report Share Posted September 25, 2011 The gun is all stock. Quote Link to post Share on other sites
ChileRelleno 7,071 Posted September 25, 2011 Report Share Posted September 25, 2011 Well, in that case... Convert the son of a bitch, the new FCG will be a huge improvement. Normally one would want to make sure the gun was functioning well, with no warranty issues before conversion, so lets address the issue at hand first. Pop the dustcover off, remove the recoil assembly & bolt/boltcarrier. Then cycle the FCG by hand, observe closely to ascertain where/what is the problem. Something will be visibly amiss. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.