1200hd_cj 3 Posted May 17, 2012 Report Share Posted May 17, 2012 Ok if i install the gas bushing on my 1919 to run low brass do i have to remove it to run high brass what could it damage? Thanks for the info. Quote Link to post Share on other sites
saiga545 47 Posted May 18, 2012 Report Share Posted May 18, 2012 1st off I love your avatar! Is that a patch you can buy? I've ran a lot of high brass 2 3/4" with the gas bushing and have not noticed any excessive wear / damage. The recoil is a little heavier than without the bushing though. I haven't tried 3" loads with the bushing. I haven't been brave enough to try it . Quote Link to post Share on other sites
1200hd_cj 3 Posted May 18, 2012 Author Report Share Posted May 18, 2012 Thanks yes i think you can find the patch on ebay or at hillbilly223.com i need a gas bushing so i can run lo brass Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.