blueknight6670 0 Posted April 4, 2014 Report Share Posted April 4, 2014 Is the Tapco Saw grip the only one that will work with the Tromix trigger guard? It has the nut welded to the bottom and I don't know if it has the proper angle for a standard ak grip? I'm fairly sure the ak grip screw is the wrong thread and thread angle. It would suck if that's the only grip that works. I wanted to try and run the md arms molot grip. Quote Link to post Share on other sites
MikeDelta 0 Posted April 5, 2014 Report Share Posted April 5, 2014 (edited) Ive got a Falcon Ergo grip with a Tromix TG. the supplied screw was too long, but with a shorter screw it works fine. The limiting factor for most grips is probably going to just be the screw length, since it cant pass through, and bottoms out on the welded nut. Edited April 5, 2014 by MikeDelta Quote Link to post Share on other sites
HighPlainsDrifter 466 Posted April 5, 2014 Report Share Posted April 5, 2014 Ive got a Falcon Ergo grip with a Tromix TG. the supplied screw was too long, but with a shorter screw it works fine. The limiting factor for most grips is probably going to just be the screw length, since it cant pass through, and bottoms out on the welded nut. Cut the screw down with a dremel, file the edges and you are good to go. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.