Barrel fixture1
Used to short sections of 3"X1 1/4" channel iron. Some stuff I had used for another project many years ago. Each channel has a 1/2 hole drill on center near each end. Then I cut out the center section to allow the barrel end to slip through and become the front trunnion support and the upper channel was cut out to allow the receiver to slip through. The upper channel is the pusher part of the press. The two 1/2 20 grade 8 studs supply the force to push the barrel out. It didn't take as much effort as I thought however the barrel popped each time it moved. I worked almost better than I thought it would.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.