Rustler07

Okay so I took out the new setup to see how it felt and all seemed well the first run which I would have to say I felt good about the work I did. But of course there always has to be some kind of issue that presents itself. After the second outing I noticed that there was a little slop in the fore grip. So I took it apart and found that the bolt/screw that secures the fore grip to the gas block was bent into a S-shape. So I replaced the screw and inserted a spacer between the fore grip and barrel to see the would lock it down and keep the fore grip from bending the screw and the answer to

Sorry about the bad pics on the post I fixed them

Well I found this sight and decided to try it out. http://store.carolinashooterssupply.com/servlet/-strse-921/CSS-TACTICAL-SAIGA-12/Detail So I have a saiga model IZ-412nm I went looking for a rail system for this gun and found that there are no rail systems that I could find that will fit this gun since the rear sight block wraps around the barrel. I decided to try my luck and see if I could make one fit. I bought the MTU002 rail model by UTG. Now I knew from the start that I would not be able to use the upper part of the rail because of the way the gas tube is setup on this gun.

I ended up taking my gun to have someone look at it and he said its got some kind of epoxy on it. He gave me 2 options he would try to heat it off or cut it off, but he warned me that he did not like the finish on the barrel and was worried that the heat may cause the finish to crack and flake off, so it ended up being cut off. There was quite a lot of glue that was holding the sight in place. Even after cutting it he had to really convince the sight that it wanted to come off. There was a good amount of epoxy left on the barrel and its hard as a rock. Ended up sanding some of it down so I