eyegun

I had Tood Koonce (Koonce Custom Gunworks) turn down my muzzle and install a '74 FSB. Didn't cost much and didn't take much time. I run a standard '74 brake (that I bored out to roughly .410 for a little margin of safety). Very very mild recoil, somewhat of a blast. I still have to finish it- oh well that will be yet another summer project for me. I still don't know what to do about the front HG retainer. I'm using a dinzag bolt on but I'm not feeling the love on that one....

It's definitely not a Robinson Arms block (I have one of those). Other than that I don't know.

What's the deal with the extra little part?

Got one the other day. No install instructions- it only had a schematic drawing. When I went to install it, it wouldn't drop on- the fit over the barrel was too tight. I tried to slip it from the muzzle end back, but no-go. I don't have a problem pounding it on and ruining the finish under it, but if I'm going to do that I want to make sure that is the right way..... Any FIRST HAND experience or am I the first one here with one of these?

Longtime lurker, first time poster on this board. Already searched this board and others for my answer but didn't find it anywhere. Recently got a new Tromix S12. Finally took it out to the range the other day and the dang thing would not cycle using standard department store clays loads. Specifically what is happening is a FTE- sometimes the empty case jams between the BC and topcover, sometimes the bolt is closed and the empty case still in the chamber. Happens about 80% of the time. I'm using the factory 5 rd mag (many AGP mags on order and/or waiting list). Haven't shot a Saiga b