J R

Thanks chileRelleno, The ports are about a !/8 inch not ¼ inch, DA on me! I have a gas port on the left side right on what I would call the gas block and it slants down Looks like nothing has come out of it because when I swobbed it it was clean. What is that actually for, to release gas? I Can stick a pipe cleaner through both holes and see it in the barrel. If I remember right, on these Sagas you have to heat the front and rear of the gas tube block to remove it, am I right? Thanks for your help in this. These type guns get to me. I mostly work on bolt guns, changing barrels out a

Yes 3 inch mag shoots good even buck shot. I did shoot one slug through it and it went and ejected fine. 2 pass ports looks like just under ¼ inch each. Factory gas plug in it too.

Hello I am new to this site. I have worked on a couple of these 12 gauge shotguns but this one is getting to me. I can shoot 12 mags in this with no problem but when I try anything else it will not eject or it stove pipes, again mags shoot great and eject. I have turned the gas buffer to every number, made sure the acc. screw on the rail is sealed with blue lock tite, I have taken it apart and put a camera down in there and it is clean. I did see where some one cut the front spring but counted the coils and they only cut one coil off. Again I have used all sorts of ammo I even shot an old Win