Thor's Hammer

Some good advice I got from this forum on that job was to file to a slight taper when fitting for the rear trunnion clearance. Get it so it will hand fit to within a 1/4" of the receiver, place some duck tape over back side of the block to protect the finish, then give it a few smacks with a rubber mallet to seat it firmly in place. When I was test fitting I put some black ink marks on the two freshly filed edges with a sharpie so that when I pulled it back out I could try to get a disturbed condition on both marks to ensure I was getting even contact on both sides. And don't forget to pre

Hmm... Ask your FFL in Guam if there is a CONUS FFL that they have worked with in the past that can take delivery and then forward it to Guam? Just a thought. They should know if this can legally be done.

Yeah, I thought the same thing. I might just save $70 waiting till Centerfire shows em in stock. I seriously doubt they will go for lower than that in the foreseeable future. Blah, blah, blah... Make a long story short, at lunch break I clicked finalize checkout and about 3 hours later they sent me my tracking number. I'm so weak. That $70 is coming out of my beer allowance.

Hello everyone, First off I want to thank everyone for the input that makes this forum so informative. Theres not much I can say about that, that hasn't been said before. Just a big thank you from a long time lurker. On with the WTB, I'm looking for a Saiga monte carlo wood stock and fore grip. If you have one to sell, just let me know.