hbsseller 3 Posted April 30, 2006 Report Share Posted April 30, 2006 Pretty basic question. I got my Corsak 22 laser from Acca47. It installed fine (works great too). But I was not sure how to adjust it for the equivalent of gas setting #2. Any suggestions? BTW - did anyone change the on/off button? Seems a little "stubby". Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted April 30, 2006 Report Share Posted April 30, 2006 I have mine adjusted for #1 only since that's the only setting for shooting slugs. I don't think you can use it for both. Don't know about the stubby button , mine has a pressure switch. Quote Link to post Share on other sites
beerslurpy 1 Posted May 1, 2006 Report Share Posted May 1, 2006 I've got a pressure switch as well. You adjust it by turning the tube. I indexed the wire to where the 1/2 numbers were before I installed it. I have it on the "mostly closed" setting for full power loads. I know that turning it 180 degrees gets me the other selection, if I ever happen to have bean-bags. Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted May 1, 2006 Report Share Posted May 1, 2006 After seeing this again I understand what you are asking now. Since it doesn't have numbers on it for the one and two settings you need to make some kind of marks on it in the same positions as the one and two on your blind plug you are replacing. The number 2 setting should index the detent pin with the beveled cut on the back in the 6 oclock position. Make another mark on the exact opposite side so you can turn it 180 degrees for shooting magnum loads. What I was saying was you can only zero the laser for #1 or 2 but not both. Quote Link to post Share on other sites
hbsseller 3 Posted May 2, 2006 Author Report Share Posted May 2, 2006 After seeing this again I understand what you are asking now. Since it doesn't have numbers on it for the one and two settings you need to make some kind of marks on it in the same positions as the one and two on your blind plug you are replacing. The number 2 setting should index the detent pin with the beveled cut on the back in the 6 oclock position. Make another mark on the exact opposite side so you can turn it 180 degrees for shooting magnum loads. What I was saying was you can only zero the laser for #1 or 2 but not both. Thanks - That's exactly what I wanted to know! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.