dagast2 0 Posted February 28, 2007 Report Share Posted February 28, 2007 According to the conversion guides I've read most saiga's come with this hole pre-drilled. Is there anyway to determine if this hole is drilled already on my gun without drilling out the existing trigger guard? If I determine that my gun doesn't have the hole already drilled, how complicated is this procedure? Does it have to be a diagonal threaded hole or just a simple one? Quote Link to post Share on other sites
Chimera 0 Posted February 28, 2007 Report Share Posted February 28, 2007 Take the top cover off. Look between the trigger hooks/disconnector (second pin back from the magwell) and the trigger. There should be a square hole that is covered by sheet metal on the outside. The new grip bolt nut goes through this hole and has the angle built into it's shoulders. Quote Link to post Share on other sites
dagast2 0 Posted February 28, 2007 Author Report Share Posted February 28, 2007 Take the top cover off. Look between the trigger hooks/disconnector (second pin back from the magwell) and the trigger. There should be a square hole that is covered by sheet metal on the outside. The new grip bolt nut goes through this hole and has the angle built into it's shoulders. Thanks! I will check this out when I get home from work. If it's not there I might be in trouble... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.