bowastya 0 Posted September 3, 2008 Report Share Posted September 3, 2008 I purchased Tromix S12 DIY trigger guard and FCG which comes with a "Shepherds Crook". What is this for and where does it go? I'm stumped and at a standstill on my re-assembly until one of you kind brethren shed some light on this for me. Thanks in advance..... Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted September 3, 2008 Report Share Posted September 3, 2008 You need to put it on from the rear and against the left sidewall of the receiver. The hooked end clips around the trigger pin and the long end holds the hammer pin in place by spring tension. Check out Tony's thread in his biz section, where he first introduced the DIY TGs. I believe he explained it good there. Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted September 3, 2008 Report Share Posted September 3, 2008 Here check this out....yours is most like the Bulgarian. Quote Link to post Share on other sites
TonyRumore 1,332 Posted September 3, 2008 Report Share Posted September 3, 2008 3rd one from the top. Tony Quote Link to post Share on other sites
bowastya 0 Posted September 3, 2008 Author Report Share Posted September 3, 2008 Thanks guys - mission accomplished. First conversion complete - pow pow pow Quote Link to post Share on other sites
DrWho 10 Posted January 31, 2009 Report Share Posted January 31, 2009 ok. should i use the tromix shepherds crock or wait for my "something" pins to come in from dinzag? i don't have my screws for tg, so can wait a few days... any benefits? fingers already sore. Quote Link to post Share on other sites
CavScout888 0 Posted May 5, 2010 Report Share Posted May 5, 2010 I needed this info too. hahaha. I think the one in my AMD is f'ed too. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.