D.O.A. 0 Posted January 11, 2005 Report Share Posted January 11, 2005 I just got my 76mm mags from CDNN (only $10 each so I couldn't pass it up). I was looking at one trying to figure out how to get 70mm shells to cycle right and it seems if the shell sits a little lower up front it will work. By mistake I put the follower in backwards (it's a little sticky but it fits) and this actually put the shell in the right place. I have some trouble with loading the mag but after it's full the rounds cycle fine, I havn't shot it yet but cycling it fast by hand works great. Quote Link to post Share on other sites
D.O.A. 0 Posted January 11, 2005 Author Report Share Posted January 11, 2005 Ok update on this. I can no longer get the mag to chamber the last round(it sits too low in the front). The good news is that with the follower turned around it gives you a flat base on which you can form your own ramp that is the right level. More on this as I do more experamenting. Quote Link to post Share on other sites
TWGLADF 0 Posted January 26, 2005 Report Share Posted January 26, 2005 hey both my 3 inch mags cycle all five 2 3/4 inch rounds flawlessly. all i did was turn the follower around like stated. didn't turn the whole spring, just the follower. that was a great idea! Quote Link to post Share on other sites
D.O.A. 0 Posted January 26, 2005 Author Report Share Posted January 26, 2005 Glad it worked out, My have been cycling good too. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.