supercopjason 0 Posted September 20, 2009 Report Share Posted September 20, 2009 (edited) Ok I have been on here searching for about a week and have found quite a bit of information but am looking for questions that were not answered. I see that some recievers already have the PG nut hole already cut but mine does not. When I measure the 1.6" from the back of the reciever as in the templates the nut hole would be within the saiga trigger hole ____------- -------____ So it would look a lot like that thins area cut for saiga trigger and then direct to PG nut hole. Does that sound right? Also how did you guys cut the nut hole out? The only thing I can think of is drill some holes and file it flat. Is there a write up on the 308 and I'm just missing it. Edited September 20, 2009 by supercopjason Quote Link to post Share on other sites
fxhart 14 Posted September 20, 2009 Report Share Posted September 20, 2009 Yeah that's how it should look. My .308 did come with a PG nut hole so I guess I lucked out. For my S-12, I measured out the hole, drilled and dremeled. It's a bit hacky looking but the hole is where it needs to be. Quote Link to post Share on other sites
saigafreake 27 Posted September 20, 2009 Report Share Posted September 20, 2009 i drilled the 4 corners of the hole with small drill bit and cut hole to hole with a dremel. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.