wispa78 1 Posted April 8, 2010 Report Share Posted April 8, 2010 (edited) I recently converted my rifle. Originally I had the intention of installing the BHO lever but changed my mind during the conversion. Since there's a space between the wall of the receiver and the hammer I'm thinking I should use something (a washer maybe?) to fill in the gap. I've already taken it out to the range once and it works great. I'm concerned about the hammer spring though. The right side looks to be sitting a little more slanted than the left side. This is due to where the hammer was cut to allow for the BHO lever be installed. Am I probably going to run into trouble if I leave it be? Has anyone found a good way of filling in the gap? My other option would be to order another hammer that is not cut. What would you guys do? Edited to add...Sorry, I forgot we have a conversion forum too. If this needs to be moved there I understand. Edited April 8, 2010 by Angelo Quote Link to post Share on other sites
Rockina 60 Posted April 8, 2010 Report Share Posted April 8, 2010 (edited) If your concerned, just use a flat washer to take up the space, pretty sure it's not needed though. Edited April 8, 2010 by Rockina Quote Link to post Share on other sites
wispa78 1 Posted April 9, 2010 Author Report Share Posted April 9, 2010 If your concerned, just use a flat washer to take up the space, pretty sure it's not needed though. Thanks! That's what I was thinking, but just wanted to stop by here to get someone's opinion. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.