cobravenom39 17 Posted December 1, 2010 Report Share Posted December 1, 2010 Like the title says, I know some of you guys have messed this up before and I figure I'll let you guys tell me what to do to start! Thanks! Quote Link to post Share on other sites
calvin118 2 Posted December 1, 2010 Report Share Posted December 1, 2010 I have had the best luck cutting horizontally through the dimples across the fsb and barrel shroud with a reinforced dremel cutting tool. Quote Link to post Share on other sites
cobravenom39 17 Posted December 1, 2010 Author Report Share Posted December 1, 2010 I have had the best luck cutting horizontally through the dimples across the fsb and barrel shroud with a reinforced dremel cutting tool. I was going to do that as well, but I figured drilling out the dimples would relieve some pressure. Quote Link to post Share on other sites
jamesavery22 54 Posted December 1, 2010 Report Share Posted December 1, 2010 I'll check when I get home but exact size doesnt matter much. Just get a drill bit thats a hair smaller than the diameter of the dimple. Was going to press the FSB off but noticed you can just whack it off with a rubber mallet... They aren't installed with tons of force like the GB. Quote Link to post Share on other sites
ACWeller 3 Posted December 2, 2010 Report Share Posted December 2, 2010 how do you tell if the FSB has dimples? I'd like to remove the rest of the barrel shroud and thread it but I really fear having the UGLY dimples. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.