Revolver Ocelot 3 Posted May 17, 2011 Report Share Posted May 17, 2011 Just set this block up to my saiga tonight. Noticed that if i keep it where the old block would be the barrel would stick out a little bit passed the block. I know it seems very trivial since its only a little bit off but would it be better to hav ethe barrel and block lined up even or to put the block in the exact same spot the old block was? Quote Link to post Share on other sites
stnls1911 55 Posted May 17, 2011 Report Share Posted May 17, 2011 It's negligible in my eyes. If it lines up exactly like that after removing the factory FSB, I wouldn't worry about it. Quote Link to post Share on other sites
schultze13 354 Posted May 17, 2011 Report Share Posted May 17, 2011 (edited) It won't hurt anything sticking out that little bit the flash hider will cover it up. If you try to move it that little bit you may end up with one big slot in stead of two seperate slots for the pins because the amount is so little.JMO See even this factory Bulg. barrel is not flush. Edited May 17, 2011 by SCHULTZE 1 Quote Link to post Share on other sites
Revolver Ocelot 3 Posted May 17, 2011 Author Report Share Posted May 17, 2011 Sounds good. thanks for the reassurance guys. Pic really helped. Quote Link to post Share on other sites
mikebaker1129 19 Posted May 28, 2011 Report Share Posted May 28, 2011 I made the same observation on my Saiga.I had the same question as reveolver. Thanks for clearing it up ! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.