bowogre 0 Posted April 13, 2012 Report Share Posted April 13, 2012 I just ordered a 15 round mag for my .410 the other day and it finally arrived. I put it into the gun and it looks sweet! As I was admiring it I went to pull the bolt back and it won't slide back. With the mag in I can only open the bolt about 1/4 of the way. The mag is a SMG 15 rounder. Do I have to fit this mag to the gun, or do I need to try another mag? The only mag I have used so far is the factory 4 round mag, and the gun runs like a sewing machine. Any help would be greatly appreciated. Quote Link to post Share on other sites
G O B 3,516 Posted April 13, 2012 Report Share Posted April 13, 2012 Post some pix to feed the sharks around here and I am sure that you will get some help. Quote Link to post Share on other sites
WhiskeyMinion 300 Posted April 13, 2012 Report Share Posted April 13, 2012 I needed to sand/file the follower a hair on a few of mine. Look and see if there are any burrs or molding marks interfering with the bolts action. Quote Link to post Share on other sites
bowogre 0 Posted April 14, 2012 Author Report Share Posted April 14, 2012 I'll look at it tonight after work. It does look like the follower sticks up significantly higher than the stock mag. Thanks. Quote Link to post Share on other sites
bowogre 0 Posted April 19, 2012 Author Report Share Posted April 19, 2012 You guys were right on. I sanded it a little by a little until the bolt would clear the follower. I'm taking it out now to run it, I'll let you know if it doesn't work right. Thanks for the help. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.