nukebabysitter 1 Posted September 7, 2012 Report Share Posted September 7, 2012 Please help. I was able to score some of the Bulgarian Stocks and am having problems getting it installed on my S12. I'm replacing an ATI fiberforce and I am using a RAM S12 trigger guard (the one where you don't have to cut the extra hole in the receiver). I ran a bolt through the RAM trigger guard and used a nut and washer for the ATI, but the bulgarian does not have the same set up w/in the grip. Any ideas would be great. Thanks in advance....... Quote MultiQuote Edit Quote Link to post Share on other sites
red308 54 Posted September 7, 2012 Report Share Posted September 7, 2012 you could get a piece of allthread and cut it to length and use a nut and washer on both ends or find a really long and skinny machine screw.if you use allthread make sure you thread the nuts on past where your going to cut it then you can thread them of and will act like a thread chase and clean up your cuts. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.