emf 2 Posted March 23, 2013 Report Share Posted March 23, 2013 (edited) I'm too new to this whole thing to understand what is going wrong here. I have not installed a bullet guide and that is the factory magazine. What is causing the bolt to stay open like that? It doesn't happen every time. Sometimes I can rip off ten rounds without issues and other times this will happen on about every other shot. Edited March 23, 2013 by emf Quote Link to post Share on other sites
Superhawk138 202 Posted March 23, 2013 Report Share Posted March 23, 2013 Check you're hammer spring and where the hooks make contact with the trigger sometimes they slide inwards and cause problems 1 Quote Link to post Share on other sites
richUK 90 Posted March 23, 2013 Report Share Posted March 23, 2013 Looks to me as though the spent case isnt ejecting and as the bolt carrier moves back the next round is rising from the mag but cant go anywhere because of the non-ejected case and it is causing the bolt and carrier to stay back.I would say it is possibly an extractor problem going off what I can make out... Quote Link to post Share on other sites
TYBOY 33 Posted March 23, 2013 Report Share Posted March 23, 2013 Try removing the dust cover and the firing pin. Then hand cycle (with live rounds) and visually identify what the problem is. If you are at a range or have a safe area to point the gun (in case it goes off while cycling somehow), disregard firing pin removal. Just my .02 cents. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.