alduro 0 Posted May 1, 2004 Report Share Posted May 1, 2004 I am looking at the Bulgarian bullet guide offered by K-Var, the one with the rivet. I am wondering, does this rivet mount into the side of the reciever next to the end of the barrel and curve downward? Or am I supposed to drill a hole into my reciever? Quote Link to post Share on other sites
Tengu 0 Posted May 1, 2004 Report Share Posted May 1, 2004 forget using the rivet and drill and tap a hole for a screw. I made my "bullet guide" from a piece of 3/4 inch pipe. I never did anything like that before and it came out fine. I attached it with a 6/32 sheet metal screw with Locktite and it has remained in place after 1000rds fired. If I do another conversion I will buy a guide from K-var and use it just for a change of pace. Quote Link to post Share on other sites
Guest FULL_AUTO_990 Posted May 2, 2004 Report Share Posted May 2, 2004 here is the website, it tells you step by step on how to make your own bullet guide for your saiga. http://www.cross-conn.com/Saiga_Conversion/step_8.htm Quote Link to post Share on other sites
alduro 0 Posted May 2, 2004 Author Report Share Posted May 2, 2004 I just want to know where the rivet is to go. If I use this bullet guide do I still have to drill into my reciever? Quote Link to post Share on other sites
mrapathy2000 0 Posted May 2, 2004 Report Share Posted May 2, 2004 you still have to drill yes. good luck riveting that. easier to thread it and affix it with a screw. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.