jedgemon 0 Posted October 14, 2006 Report Share Posted October 14, 2006 Anybody know the length? Tapco offers a 6.25 and a 5.25? Also on install all i have to do i drill out the demple correct? Quote Link to post Share on other sites
O.S.O.K. 0 Posted October 14, 2006 Report Share Posted October 14, 2006 These are screwed into the bolt carrier and held in place with a press pin. You need to press the pin out, unscrew the piston, replace with the new one, drill a hole in the base of the new piston and push the pin back in. I would have to measure the piston on mine to determine - measure yours and add a half inch for the threaded base. Quote Link to post Share on other sites
jedgemon 0 Posted October 14, 2006 Author Report Share Posted October 14, 2006 These are screwed into the bolt carrier and held in place with a press pin. You need to press the pin out, unscrew the piston, replace with the new one, drill a hole in the base of the new piston and push the pin back in. I would have to measure the piston on mine to determine - measure yours and add a half inch for the threaded base. this push pin would be the two little dimples straight across from each other Quote Link to post Share on other sites
Tokageko 8 Posted October 18, 2006 Report Share Posted October 18, 2006 Indeed it would. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.