KTR03 0 Posted June 21, 2007 Report Share Posted June 21, 2007 Quote Link to post Share on other sites
Etek 32 Posted June 21, 2007 Report Share Posted June 21, 2007 Quote Link to post Share on other sites
KTR03 0 Posted June 22, 2007 Author Report Share Posted June 22, 2007 Thanks for the info. Do those pins slide out easily? Anything to be careful off? I'm not mechanically the most competant person in the world. D Quote Link to post Share on other sites
Etek 32 Posted June 23, 2007 Report Share Posted June 23, 2007 Pull the hammer spring ends up and hook them on receiver, (Gets them out of the way).Push the disconnector pin retainer spring down and push the disconnector pin out from right to left JUST until it pops free of the right side. You can now pivot the disconnectot/trigger hook assembly out of the way of the selector. A good site is http://www.gunsnet.net/Linx310/fcgremoval2.htm Quote Link to post Share on other sites
Genocide 0 Posted June 23, 2007 Report Share Posted June 23, 2007 Thanks for the info. Do those pins slide out easily? Anything to be careful off? I'm not mechanically the most competant person in the world. D Your not going to break anything, once you disassemble the internals you just gotta put them back together correctly. But seeing how your not completely taking the trigger parts out you should be fine. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.