akclan33 0 Posted May 1, 2008 Report Share Posted May 1, 2008 Im looking for a template that i can put over the recevier and and mark where the pistol grip hole goes Quote Link to post Share on other sites
Franky 2 Posted May 1, 2008 Report Share Posted May 1, 2008 Here's one for another caliber http://www.cross-conn.com/Saiga_Conversion/ . Quote Link to post Share on other sites
AKATTACK 5 Posted May 6, 2008 Report Share Posted May 6, 2008 Hope this works. Quote Link to post Share on other sites
Azrial 1,091 Posted May 6, 2008 Report Share Posted May 6, 2008 That looks a standard AK print. It is a nice print, but I do not think that it is accurate for a Saiga 12. Quote Link to post Share on other sites
AKATTACK 5 Posted May 7, 2008 Report Share Posted May 7, 2008 (edited) That looks a standard AK print. It is a nice print, but I do not think that it is accurate for a Saiga 12. You are correct, it is indeed for a AK rifle, however it will work in locating the pistolgrip nut hole because it is in the same exact location on both the rifle and shotgun. I used that template when I converted my S12 several years ago. The square with the X in it is the hole that needs to be marked and cut. Edited May 7, 2008 by AKATTACK Quote Link to post Share on other sites
Azrial 1,091 Posted May 7, 2008 Report Share Posted May 7, 2008 Thanks! Quote Link to post Share on other sites
Navy87Guy 1 Posted May 7, 2008 Report Share Posted May 7, 2008 FWIW, I printed the template from the Crossconn tutorial. Even though it says "not to scale", the measurements were dead on. Jim Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.