rangerruck 0 Posted January 13, 2009 Report Share Posted January 13, 2009 I just tried to email them earlier, but got a failure notice. So I figured the homies here would know; I just bought 2 of the fabulous trigger pacs from Texas ak, now a vendor listed on Saiga 12, and I am going to go ahead and do full conversion However, if I buy the buttstock, and pistol grip from Dinzag, along with the bullet guides, do the stock and grip, as well as other parts, come with the neces- sary hardware/screws/nuts/etc. to assemble them/put them on? and if not, does Dinzag sell the hardware? Thanks Rangerruck. Quote Link to post Share on other sites
jamesavery22 54 Posted January 13, 2009 Report Share Posted January 13, 2009 (edited) I've never used the original stock mounting setup(always hacked it off and used a different rear trunnion) but I ASSume you can reuse the same screws that were in the factory stock. As for the PG I don't believe that comes with the nut and threaded rod. Namely since he sells that separately. Its part # "AKPGNS" on this page http://dinzagarms.com/misc_parts/misc_parts.html Dinzag has two options for each type of bullet guide. One thats a "kit" and one thats just the guide. The kit comes with a drill bit to drill the hole in the receiver, a tap to tap the drilled hole, the correct socket cap hex screw, an Allen wrench for the screw, and the guide. So everything you need. Just make sure you get the kit Edited January 13, 2009 by jamesavery22 Quote Link to post Share on other sites
ernestmayhand 10 Posted January 13, 2009 Report Share Posted January 13, 2009 I reused my factory stock screws (2 of the 3) in the K-Var stock I got from Dinzag. Just have to drill a couple holes in the stock. The PG nut he sells comes as shown, just the PG nut. I know the SAW grip comes with the 6mm bolt for the PG nut. Dinzag also sells the trigger guard hardware so don't forget that. Quote Link to post Share on other sites
mollysman420 19 Posted January 14, 2009 Report Share Posted January 14, 2009 What Ernest sayed! Quote Link to post Share on other sites
rangerruck 0 Posted January 14, 2009 Author Report Share Posted January 14, 2009 What Ernest sayed! cool , good info; so then the origional Saiga trigger guard no worky, huh? Quote Link to post Share on other sites
rangerruck 0 Posted January 14, 2009 Author Report Share Posted January 14, 2009 Oh no; I see it can use the origional trigger guard, you just need to get the extra screws for it to be used. Quote Link to post Share on other sites
cellsworth 21 Posted January 14, 2009 Report Share Posted January 14, 2009 Oh no; I see it can use the origional trigger guard, you just need to get the extra screws for it to be used. Yes, the original trigger guard can be modified (trimmed) and reused. I just tuck the front end under the mag catch tower and screw the back end down. It works great. Quote Link to post Share on other sites
Diocoles 0 Posted January 15, 2009 Report Share Posted January 15, 2009 I got a bullet guide for my 7.62x39 and the only thing I needed extra was a tool to hold the tap. $7 at ACE. Using his instructions and being very careful, it went perfect and both the factory and hi cap mags feed like butter into a hot ... nevermind.. It worked great. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.