BHO? after .410 conversion

[clay1003 0]

Friends.. I'm certain this topic has been covered numerous times. Could someone point me to the info concerning re-installation of the BHO for my saiga .410?

I'm down to the the wire and so far it's been smoothe sailing.. with the exception of the BHO.

All the instructions I've found don't mention it. Is it eliminated by necessity? Or can I re-install it? How? Spring?

HELP

Thanks,

Clay

[Cobra 76 two 2,677]

As funny as it may sound.....do a search for "dental floss" and see what comes up.

[clay1003 0]

As funny as it may sound.....do a search for "dental floss" and see what comes up.

 

Nothing comes up except your response mentioning dental floss. Can you be more specific?

Thanks,

Clay

[Cobra 76 two 2,677]

There are numerous threads on here describing the procedure. One way is to use some floss or srting, wire, etc, and run it up through the bottom of the BHO slot, through the loop in the spring (long leg toward the front), and back down through the slot.

Put the spring and the BHO in with the short leg of the spring hooked on the notch in the BHO. Put the hammer in and insert the hammer pin, while lining up the hole at the front of the BHO lever. Pull down on the string to hold the spring in position while you put the axis pin through from the left, through the trigger sleeve, and seat it in the receiver holes.

 

There's also a way to do it by putting the rear pin in first. Go to CSS's business section and click on the link to his video on youtube.

 

Here ya go...

[whitetrashrn 74]

I grab the top of the spring with heaostats (clamping medical pliers) push the spring down and push the pin through.