BHO BS

[dieb4iwake 60]

so i cannot get the hammer pin to go through the hammer and BHO enought to get the retaining plate in place

when i take it all out and take the spring off the hammer and put it together it will fit enough to get the retaining plate in

so i give up. any help?

[GregM1 241]

did you try inserting a pin through the opposite side to hold all in place until you drive it out with the one your installing.

[dieb4iwake 60]

yeah i did that too

it will go through the BHO but not far enough through to insert the retaining plate

Edited August 2, 2009 by dieb4iwake

[GregM1 241]

i did the hammer and BHO first then i installed the retaining plate when i added the safety lever and it slide into place from there.

 

check this vid around 12:30 +

http://www.vimeo.com/2787027

Edited August 2, 2009 by GregM1

[Rhodes1968 1,638]

That BHO has made many grown men cry like little girls...you are not alone.

[nalioth 405]

60,000,000 Kalashnikovs have been made w/o that devilish POS.

 

We only have them because they add points to the importation criteria (apparently 'sporting firearms' have bolt hold opens)

 

 

Throw the SOB away, weld up the slot on the bottom and enjoy your Saiga.

[dieb4iwake 60]

60,000,000 Kalashnikovs have been made w/o that devilish POS.

 

well add one Saiga to that list

 

Edit: emphasis on POS

Edited August 3, 2009 by dieb4iwake

[lakedweller 10]

Well I have to have a BHO because I shoot at a state range here in MI and the bolt has to be open between rounds. POS or not I am stuck and I actually do not mind......