CBR Shadow 53 Posted October 6, 2011 Report Share Posted October 6, 2011 I bought a couple Promag 10 rounders through CSS which came in this afternoon. They wont click into the gun right now. Can I file these down similar to the way I did with the 20 round drum for a tight fit? Also I ordered the CSS puck. Probably a dumb question, but does the little "nipple" go backwards toward the bolt/carrier? I assume that's the correct way to place it. Quote Link to post Share on other sites
garnaz 215 Posted October 6, 2011 Report Share Posted October 6, 2011 If you check back at css site they explain direction of install. Quote Link to post Share on other sites
CBR Shadow 53 Posted October 6, 2011 Author Report Share Posted October 6, 2011 Found it - thanks. Incase anyone else wonders the answer to this: CSS Performance Puc installs easily with the flat side towards the front of the gun and the "Tail" towards the back. If someone could answer about the promag 10 rounders that would be great. Quote Link to post Share on other sites
storm6490 2,768 Posted October 6, 2011 Report Share Posted October 6, 2011 yep, just take a C hair off at a time and follow the same procedures as the MD directions suggest. you can also slam that bitch in there and see where it mars the plastic. take some off there one C hair at at time! lube with silicon spray afterwards to seal plastic and make the hack job disappear. Quote Link to post Share on other sites
CBR Shadow 53 Posted October 6, 2011 Author Report Share Posted October 6, 2011 Excellent - I will try this when I get home this evening. Thanks for the advice. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.