unsichtbar

I could use a free conversion never won anything before thanks for the opportunity. I have a AK conversion picking up tomorrow, and have had several done. Hope you get some help to respond inquiries.

I need a couple of frount latch kits also any up dates? Please PM Me if any come up

http://www.mygunsnorthwest.com This fellow has made a run of AK folding stock 4.5 and 5.5 trunions,frount and back latches, pins and springs. He has allot of pics of the on AK Forum I think. He was selling trunions $79 and latches for $12. He was out of trunions going to do a run this winter, you might give him a call, he may have the othe parts in stock

WTB: I have a AK 105 build that has been sitting for a while is one part short having a builder start. Need 5.5 folding stock hardware complete trunion, latches, pins and springs $125. prompt payment. Please email me if you have one or a scorce. Note:I have had this posted in another form but little responce

Thanks for the replies, the bolt has been completely cleaned and lubricated and checked for burr with a hand loop magnifier. We also did a light polish around the bolt face, still about one or two every 60 rounds jumps up on to of the extractor. I would think that the failure to feed the case would happen more often if there was some obstruction. I will break it down and try all the suggestions once again. Maybe buff the bullet guide a little more?

The round is not chambered, bolt is about half an inch open. You can see then case which on top of the extractor

A friend has an AK 74 which is a Center fire system rifle on a Nodak receiver (about 300rds fired), at least one to two times each 60 rds (2x 30rd magazines) it has a failure to feed, not first or last round either. The bolt is not fully into battery and you can see the base of the round, it is on top of the extractor/bolt. Several others have the same rifle with no problem. Tried different magazines which have proved reliable in another rifle 2000+ rds, and same thing happened. Checked the magazine guide for burr, even polished it up a bit. Magazine does not have much play, seems to be la

1814 Thanks forthe oppertunity and great product

I am installing a Tromix fire control group, is there a source for replacement trigger and hammer axel pins, rather than use the pins which were removed. I have seen the posted conversion thread using the aluminum blind post but was looking for a better material like steel blind post. I am also going to use a welded in receiver back plate ( also Tromix) with a angle of 4 to 6 degrees if anyone has an opinion or photos they would be appreciated. I have the trigger group parts on back order MA and am hoping Cobra 76 gets his BHO unit out in time for this conversion, any chance.

I am going to use a welded receiver back plate on a Saiga 12 conversion with a Ace stock, what is the correct angle to grind the receiver to obtain proper stock angle? I have searched and the only comment I have found is 3 degrees, any other advise or photos would be appreciated.